cross-posted from: https://lemmy.world/post/3754933
While experimenting with ProtonVPN’s Wireguard configs, I realized that my real IPv6 address was leaking while IPv4 was correctly going through the tunnel. How do I prevent this from happening?
I’ve already tried adding
::/0to theAllowedIPsoption and IPv6 is listed as disabled in the NetworkManager profile.
The bad practise would be to entirely disable IPv6. #ShittySysAdmin
Broke: disabling ipv6 because it’s causing security holes with software not originally built for it
Woke: disabling ipv6 because hex ip strings are too hard to type
The whole Silicon Valley, governments and economic infrastructure hangs by a thread made of bootleg shortcuts.
In this case, disabling IPv6 is actually the right move. If the VPN provider doesn’t support IPv6, then there’s no way to allow to allow IPv6 Internet traffic without causing a leak/VPN bypass. If you block IPv6 via firewall or routing it to a dead-end, it will add delays as things try IPv6, timeout, and fall back to IPv4. If you just remove the IPv6 address from the Internet interface, you have to also make sure it doesn’t get re-added by SLAAC/DHCPv6 or other interface changes (switching wifi networks, etc). As dumb as it seems, disabling IPv6 or switching to a provider that supports it are probably the best options.
The right move for the VPN provider is to support IPv6. The right move for the user is to take their business to a provider that does.
I do the same, but would like to know the correct way to hide ipv6
Haha, yeah that’s what ProtonVPN support recommended to me and I am not sure if I want to disable IPv6 globally like that. I feel (with my inexperienced brain) that there’s gotta be a way to do it on a per connection basis.
Unironically that’s one thing we do to anonymize traffic at work. We could do NAT via IPV6 but what’s the point when IPV4 already helps mask who is doing what in the office.
IPv6 is broken by design /s.