Literally billions of people are. Do you think meat just spontaneously appears in the supermarket?

Quite the opposite. Cannibalism(assuming you obtain consent) would be ethical meat consumption.

Am easy option is to check the output of lsusb and check which bus the storage device shows up on. Device 1 on each bus is the controller which will show as usb1/2/3, with every other device on that bus running at that speed.

I forget, did Pegasus end up disabling their networking after they made their initial escape? I don’t remember it being mentioned, but it makes for quite a plot hole if they continued on as normal.

Did she name her car “dick turpin”?

Can you provide an example of this? Only time I’ve encountered that behaviour was with a laptop that had a defective lid-switch.

Raid 0 offers no redundancy though. If any of those three disks fail, you lose the entire volume.

For the sake of backups, switching to Raid 5 would be more robust

smartmontools has some good functionality for interfacing with SMART via usb bridges that do not provide native functionality.

Fair. No arduino kits though?

If you’re going to the expense of putting a camera on it, why not take it a little further and slap together an arduino-based sensor suite with some logging? See if you can find any correlations in temp/humidity/gas conc that might help with diagnosis.

I just wish it was multithreaded so that i could maintain a colony for more than a week without slowing to potato speeds.

My n00b theory on it, with the proviso that I am not a developer and only have a basic understanding of multithreading, is that you would break up the map into regions, and have each regions pawns and environment handled independently by separate threads/cores while one master thread handled interactions between regions and kept them all in sync.

Regions could dynamically scale depending on how computationally intensive they are, such that when the master/watchdog thread has to wait for one thread significantly longer than any of it’s adjacent region threads, it remaps the boundary iteratively until it acheives minimal wait-time and the load is evenly balanced.

As it stands, I’ve got one core maxed out and the game running slower than realtime while my 15 other cores sit at idle like suckers.

1.2l water

240ml sodium sulfate

60ml sodium chloride

20ml xantham gum(optional for increased efficacy by keeping the solution homogenous)

Boil water, stir until fully dissolved, a small amount of solute should remain, if not, increase sodium sulfate concentration slowly until it does, indicating no free water molecules available for dissolution.

Solution should now be cooled to below 18c( freezing point) for an end product that will regulate temperature to 18c so long as it have sufficient(negative) thermal energy.

Solution of pure sodium chloride will have freezing point approx -20C, while solution of pure sodium sulfate has freezing point +35C. Adjusting the ratio of NaCl to Na2SO4 will shift the freezing point towards either end of thag spectrum, depending on what phase change temperature you are targetting.

I often stumble across jobs in Antarctica listed in my region. It’s right there in the headline, so its easy to skip over them, but i have to wonder, how else would you advertise for jobs in remote locations where most people wouldn’t even think to look?

90% of listings on aliexpress or amazon are made by dropshippers who don’t actually have any knowledge of the products they’re selling. They scrape the datasets for all of the manufacturers they source from, autopopulate any required fields and blast out a thousand listings. I’d wager the majority aren’t even human reviewed, let alone human written.

Boot into your bios and check the sata mode. A number of machines that I work with(acer predators most notoriously) will for no discernable reason switch from achi mode to rst optane, resulting in no drive being accessible to the os. Switching back to ahci resolves it.

Choo Choo!

I agree with you somewhat, but I think in the case of body parts, which require the death of a person to procure, the risk of encouraging such bad actors is significant enough that we ought not to enable any market at all except where lives may be saved by their procurement.

I would consider trophies derived from human bodies to be immoral in the same way that child pornography is. The act of transmitting a digital file does not directly cause harm to anyone, but by creating a demand for it, you are in turn driving an industry that violates the rights of people in order to keep supplying it.

For many years after western contact with Aotearoa, people were deliberately killed for the sake of producing preserved heads which would be purchased by collectors in Europe.

If there were to be a resurgence in demand for such objects, there is no shortage of people either desperate enough or cruel enough to revive the practice of killing people to produce them.

Sure, there could be systems put in place to verify that a head was procured humanely after natural death, but it would never be foolproof, and there would always be some degree of black market causing harm on the fringes in order to meet demand.

We already know that people are killed in order to feed the black market for transplantable organs, so why would we allow an industry with all of the same risks to exist purely for the sake of art?

My daughter is a very different skin colour than me. Somehow the worst I’ve encountered to date is an uppity mother who thought I was telling off a random child.

This is something I’ve never understood. Surely it is a compliment rather than an insult to effectively say “your partner is very attractive”