My router is called Jupiter, everything connected to it is named after a moon. Callisto, Ganymede, Thelxinoe, Kallichore are what I’m currently using.

You can host a Firefox sync server yourself. You could run that on something like a Raspberry Pi in your local network. If you need remote access, use something like cloudflare tunnels (although I guess that’s something else to be paranoid about).

It is more efficient to have a ship moving with cargo than without, but that doesn’t mean there aren’t additional emissions. The ratio of profit to effort is just higher because there is some profit as opposed to none. You wouldn’t load a ship up with useless mass you can’t sell just so you’re shipping something.

Your argument is like always running the heater in your car because that way the engine heat is at least used for something. Yes, technically the efficiency goes up because more of the energy in the fuel is harnessed. But that doesn’t mean the fuel usage or emissions are any lower, and in the summer the heater doesn’t do you any good either.

That’s why I don’t let every device decide individually. I know my router (FritzBox) prioritizes the pi-hole (it’s even called “preferred” and “alternative” DNS-Server in the UI)

I have my pi-hole setup as the upstream DNS in my router, with cloudflare as a secondary DNS. That way, all my devices always use the router for DNS (since that’s what is advertised in my DHCP) and the router then uses pi-hole if it’s available, or cloudflare if it isn’t. But the individual device doesn’t get to choose between different servers.

That study states that brain damage can cause more conservative views, but the reverse isn’t true. Not everyone with conservative views has brain damage.

I’m guessing it’s about documenting the assembly of safety-critical components. If some part of, let’s say an airplane fails because a bolt comes loose, the manufacturer wants to have a paper trail attached to it to prove that this specific bolt was indeed torqued to the correct spec. Connecting the wrench to the network could make this documentation much easier.

Matlab

Those adapters should definitely be fine for 24 V. Running the fans off 19 V will probably work, but they will run at slightly slower RPM (probably not a big problem for a filter).

I have the exact same setup and also didn’t get the warning yet. Maybe pihole stops the AdBlock detection?

You could use a voltage divider followed by a unity-gain amplifier to lower the output impedance, about like this: (I think that circuit could work, but I haven’t thought about it a lot, so it might not)

Not really. With that bulb, all the light is focused forward, not to the side. The light will never hit the reflector, it is only focused by the lens in the LED housing, and that isn’t enough.

From looking at the LED bulb, I can tell you that it will not work very well in that flashlight.

The reflector of the flashlight is built so light coming from a very small source (like the filament of an incandescent bulb) is directed forward in a focused beam. With the led bulb, light is coming from 10 different spots, none of them being in the focus point of the reflector. The result will be a spread out beam that won’t be bright over longer distances.

The only type of LED bulb that could work is something like this car replacement bulb that keeps the light source to a relatively small spot. But I don’t think those are available in the size you need.

One of my monitors has had a couple of dead pixels for a couple of years. I still find myself wondering sometimes if that dark spot is part of the image or just my crappy screen.

3